Plastic / Metal Material Medical O2 Sensor Envitec OOM102 3 Pin Molex Connector

Envitec OOM102 medical oxygen sensor / O2 Cell

Specification:

1. Output signal in air: 9-14mV
2. Circuit Interface: 3Pin Molex Connector
3. Accuracy and repeatability: <1% volume of oxygen, after calibration in 100% oxygen
4. Linearity error: <3% relative error
5. Response time: <12 seconds, relative to 90% relative value
6. Zero drift: <200uV placed in 100% nitrogen for 5 minutes
7. Cross interference: <0.5% volume of oxygen for:
8. 10% CO2 in balanced nitrogen
9. 80% N2O in balanced nitrogen
10. 7.5% halothane in balanced nitrogen
11. 7.5% isoflurane in equilibrium nitrogen
12. 7.5% enflurane in equilibrium nitrogen
13. 9% enflurane in balanced nitrogen
14. 20% desflurane in equilibrium nitrogen
15. Effect of temperature: -0.03% relative temperature, 25 ° C
16. The effect of pressure: proportional to the oxygen partial pressure
17. Mechanical shock impact: <1% relative error, falling from a height of 1 meter
18. Working temperature: 0°C-50°C
19. Temperature compensation: Built-in thermistor compensation
20. Temperature effect: 25 ° C -40 ° C, 3% relative error
21. Compensation (steady state): between 0 ° C and 50 ° C, 8% relative error
22. Operating humidity: 0-99% RH (a few hours in condensable air)
23. Storage temperature: -20 ° C -50 ° C
24. Recommended storage temperature: 5 ° C - 15 ° C
25. Recommended load: ≥10Ω
26. Warm-up time: <30 minutes after replacing the sensor
27. Rated sensor life: ≥1 000 000% volume oxygen hour
28. Weight: about 28g

envitec oxygen sensor

drager oxygen sensor

Plastic / Metal Material Medical O2 Sensor Envitec OOM102 3 Pin Molex Connector Images